Saturation, compression and de-essing in a vocal strip
A vocal strip puts several audio effects in 1 signal path. In GoldenVox, the order is Preamp, Tape, Compression, Tone EQ, De-esser and Air. Each stage changes what reaches the next, so a little extra drive can change how the compressor responds.
Start with the recording.
Listen to the vocal in the mix before turning anything up. If a phrase jumps out, work on its level first. If the tone feels thin, try a small amount of drive and compare it with the original at a similar output level. Louder can sound better even when the tone hasn't improved.
Separate peaks from leveling.
Fast peak control and slower leveling solve different problems. In GoldenVox, FET responds quickly, Opto levels more slowly, and Series puts them together. Choose the behavior that suits the phrase, then listen through its loudest and quietest sections.
Listen to what the de-esser removes.
Split reduction focuses on the high-frequency part of the signal. Broadband reduction turns down the full signal when the detector responds. Compare both on the same phrase. GoldenVox's Delta audition lets you hear what the de-esser removes before Air. Turn Delta off before judging the full vocal.
Check the top end after Air.
Air follows the de-esser in GoldenVox. Its lift varies with the vocal level, so check quiet words as well as loud ones. If the vocal gets too sharp, reduce Air and compare again before adding more de-essing.
Save the useful starting point.
Use a user preset to keep settings that suit a voice. Recheck them on the next recording. A different microphone position or performance can need a different amount of drive and compression.